Internet Access Kit Readme
Contents:
- General Notes.
- Macintosh Notes.
General Notes
Environment
This software runs on and is supported
on PowerPC Macintosh System 7.5 (and later), on 68K Macintosh* System 7.1 (and later) with
a 68030 (or later) processor, Microsoft Windows 3.x
and Microsoft Windows 95®. No other environments are supported.
* There is currently no Customer Support
for the 68K Macintosh
Turn your Modem On!
During the Account Creation process the
Telstra Big Pond® Home Internet Access Kit will attempt to automatically detect and
install drivers for your Modem, please ensure that your Modem is switched on and connected
to your PC.
Customer Support
If you run into problems or have any
questions, you can contact the Telstra Big Pond Home Customer Support Centre on 131-282
for the cost of a local call. The CSC operates between 8am and Midnight 7 days a week.
Please note that all operating times are Australian Eastern Standard or Daylight Savings
Time.
Macintosh Notes
Required hardware.
This installation requires that you are
using a PowerPC Macintosh or a 68K Macintosh with a 68030 or higher processor.
Required software.
For a PowerPC Macintosh You also
need to be running at least System 7.5. The System 7.5 Update 2.0 is included. If you are
running System 7.5, 7.5.1 or 7.5.2 and you have not upgraded with the System 7.5 Update
2.0 software then you should do so before proceeding. For a 68K Macintosh you will
need at least System 7.1
You need to be running OpenTransport 1.1.2.
Both OpenTransport 1.1.1 and 1.1.2 are included. If you have not installed OpenTransport
yet then you should do so before proceeding. Be sure to install 1.1.1 first and then
1.1.2.
You need to be running OT PPP 1.0 or later.
OT PPP 1.0 is included. If you have not installed OT PPP yet then you should do so before
proceeding.
|
